WESM zl Management and Configuration Guide WT.01.28 and greater

1-10
Introduction
ProCurve Wireless Edge Services zl Module
The wireless services-enabled switch still uses auto-provisioning to create
VLAN 2100 and tag the module’s internal downlink port for this VLAN. However,
you must configure the infrastructure switch’s port that connects to the RP as an
untagged member of the Radio Port VLAN.
Remember that the external switch interfaces that link the infrastructure switch and
the wireless services-enabled switch must also carry traffic on the Radio Port VLAN.
You must make these interfaces either tagged or untagged for the Radio Port VLAN,
depending on whether they must carry other traffic in addition to the wireless traffic
transmitted to and from the RP. Figure 1-2 shows the VLAN assignments if you
connect an RP to an infrastructure switch.
Figure 1-2. Manually Establishing a Radio VLAN for an Indirectly Connected RP