WESM zl Management and Configuration Guide WT.01.28 and greater

2-191
Configuring the ProCurve Wireless Edge Services zl Module
Digital Certificates
5. If you selected Server as the source in step 3, in the Source section, specify the
following for the key transfer source:
a. From the Using drop-down menu, select the protocol for the key transfer,
either FTP or TFTP.
b. In the Port field, enter the respective FTP or TFTP port number; the default
port number (port 21 for FTP, port 69 for TFTP) should apply in most cases.
c. In the IP Address field, enter the IP address of the FTP or TFTP server.
d. If you are using an FTP server, enter the login credentials:
i. In the User ID field, enter the username for your account on the FTP
server.
ii. In the Password field, enter the password for this username.
e. In the Path field, enter the path where the key is stored on the server. (If you
are using a TFTP server, this field may not be required.)
The fields in this step do not apply to key transfers from a local disk source.
6. In the Pass phrase field, enter the passphrase to encrypt the key.
Unless you enter the correct passphrase, the Wireless Edge Services zl Module
cannot install the key. However, if the key has not been encrypted, leave this
field empty.
7. In the Target section, in the File field, enter the filename of the target key file.
8. Click the Transfer button. In the Status section at the bottom of the screen, a
message is displayed, reporting whether the transfer was successful.
9. After the key transfer is complete, click the Close button.