WESM zl Management and Configuration Guide WT.01.28 and greater

3-38
Radio Port Configuration
Configuring Radio Settings
4. Select a reset option:
• If you click the Reset Radio only button, only the selected radio will reset.
• If you click the Reset entire Radio Port button, the RP for the selected radio
will reset, along with both radios on the same RP. Each radio will reset with
its specific configuration (not with the radio adoption default configuration).
Managing RP Radios
You can perform several actions on an RP radio in the Network Setup > Radio screen.
Select the radio from the list and clicking the buttons at the bottom of the screen:
■ Click the Edit button to alter a radio’s configuration. The Configuration screen
for that radio is displayed. (See “Configuring Radio Settings for a Particular
Radio” on page 3-29.)
■ Click the Delete button to delete a radio configuration and unadopt the radio.
The radio will immediately be readopted unless you have taken steps to prevent
it being so (for example, clicking the Global Settings button and disabling
manual adoption). However, the radio receives the radio adoption default con-
figuration, which writes over any configuration previously created for it.
Clicking the Delete button also erases the configuration of an RP radio that was
once adopted by this module, but is so no longer.
■ Click the Add button to adopt a RP when automatic adoption is disabled. (See
“Radio Port Adoption” on page 2-57 of Chapter 2: “Configuring the ProCurve
Wireless Edge Services zl Module.”)
You also use the Add button to create a pre-adoption configuration targeted for
a particular radio.
When you click the Add button, the Add Radio screen is displayed.