WESM zl Management and Configuration Guide WT.01.28 and greater

4-22
Wireless Local Area Networks (WLANs)
Configuration Options: Normal Versus Advanced Mode
Figure 4-15. Manually Assigning WLANs to an RP Radio
Figure 4-14 shows the Network Setup > Radio screen in which you would check this
configuration.
If you had assigned a fifth WLAN to the radio, then two SSIDs would be assigned
to BSSID 1, and beacons would advertise only one of these SSIDs.
If you want the beacons to include the WLAN with the higher index number, then
you should select the BSSID for the WLAN on the Network Setup > Radio > WLAN
Assignment screen. Then select the higher WLAN from the Primary WLAN drop-
down menu, as shown in Figure 4-13.
Using Normal and Advanced Mode Together
Rather than using advanced mode alone, it is often a good idea to first enable WLANs
in normal mode, producing a template WLAN assignment that you can then alter
with advanced mode configuration.
To use normal and advanced mode together, complete these steps:
1. Select Network Setup > WLAN Setup.
2. Configure the WLANs, as described in “Configuring a WLAN” on page 4-26.