WESM zl Management and Configuration Guide WT.01.28 and greater

4-75
Wireless Local Area Networks (WLANs)
Configuring a WLAN
Note The Advanced Configuration selection refers to how SSIDs are assigned to RP radios;
see “Advanced Mode Configuration” on page 4-11.
4. Click the OK button.
Enabling the WLAN
RPs in your wireless network will not support the WLAN until you enable it.
To enable the WLAN, complete these steps:
1. Select Network Setup > WLAN Setup and click the Configuration tab.
2. Select the WLAN that you want to enable. You can use the
<Ctrl> key to select
multiple WLANs.
3. Click the Enable button.
The icon in the Enabled column should change from a red X to a green check
mark, as shown in Figure 4-45.