WESM zl Management and Configuration Guide WT.01.28 and greater

6-6
IP Services—IP Settings, DHCP, and DNS
IP Settings
4. Configure the IP address:
a. Check the Use DHCP to obtain IP Address automatically box if you want
the VLAN to receive an IP address through a DHCP server.
Do not check this box if you want the Wireless Edge Service zl Module to
act as the DHCP server when stations successfully associate to this VLAN.
As a DHCP server, the module would, of course, require a static address on
the VLAN.
b. To configure a static address, in the IP Address and Subnet Mask fields,
enter the IP address and subnet mask.
5. If you want this VLAN to be the management interface for the Wireless Edge
Services zl Module, check the Set as Management Interface box.
6. Click the OK button to apply the changes to the running-config.
7. Click the Save link at the top of the Web browser interface to save the changes
to the startup-config.
After you assign an IP address to a VLAN, the route for the directly connected interface
is listed on the module’s route table. (See “Route Table” on page 6-12.)
Deleting the IP Address Assigned to a VLAN
If you assign an IP address to a VLAN and later decide to delete it, complete these
steps:
1. Select Network Setup > Ethernet > Configuration.
2. Select the VLAN and click the Delete button. A prompt is displayed, asking you
to verify that you want to delete the item.
Note You are not deleting the VLAN. If you have mapped a WLAN to the VLAN, the
Wireless Edge Services zl Module will continue forwarding traffic in the VLAN. You
are deleting the IP address that you previously assigned to the VLAN and removing
the VLAN from this Ethernet table (which lists the VLANs that have been assigned
IP addresses).
3. Click the Yes button to delete the IP address and remove the VLAN from the
table.
4. Click the Save link at the top of the Web browser interface to save the changes
to the startup-config.