WESM zl Management and Configuration Guide WT.01.28 and greater

6-14
IP Services—IP Settings, DHCP, and DNS
IP Routing
■ Protocol—lists the name of the protocol through which the route was obtained.
Routes can be obtained in the following ways:
• DHCP—Routes can be included with the IP address that the module
receives from a DHCP server.
• Static—Routes can be entered manually.
• Connected—Routes can be directly connected to an interface.
• Kernel/ICMP—Routes can be added to the route table if the module receives
an Internet Control Message Protocol (ICMP) redirect from an intermediate
router.
■ Route Metric—used for selecting the best available path to the destination
subnetwork. Routes with lower metric values are given preference.
■ Active—indicates whether or not IP forwarding is enabled for the route.
Adding Static Routes to the Route Table
To add a static route to the Wireless Edge Services zl Module’s route table, complete
these steps:
1. Select Network Setup > Internet Protocol and click the IP Forwarding tab.
2. Click the Add button at the bottom of the screen. The Add static route screen is
displayed.
Figure 6-9. Add Static Route Screen
3. In the Destination Subnet field, enter the IP address for the route.
4. In the Subnet Mask field, enter the subnet mask.
5. In the Gateway Address field, enter the IP address of the next hop.