WESM zl Management and Configuration Guide WT.01.28 and greater

6-39
IP Services—IP Settings, DHCP, and DNS
DHCP Server
Figure 6-26. Defining a Global Option for DHCP
7. Click the Insert button again if you need to add more options.
8. When you are finished setting up the options, click the OK button.
9. Click the Save link at the top of the Web browser interface to save the changes
to the startup-config.
Specifying the Value for an Extended Option in a DHCP Pool
After you set up an extended option, you must configure the value that the DHCP
server assigns for that option. Like typical DHCP settings, you configure these values
for particular pools.
Complete these steps:
1. Select Network Setup > DHCP Server > Configuration.
2. To configure an option for a network pool, complete these steps and then proceed
to step 4:
a. Select one of the pools in the Network Pool section. (See “Creating a
Network Pool” on page 6-24 for instructions on creating the pool.)
b. Click the Options button. The Pool Options screen is displayed.
3. To configure an option for a host pool, complete these steps and then proceed to
step 4:
a. Click the Host Pool tab.
b. Select one of the pools. (See “Creating a Host Pool” on page 6-28 for
instructions on creating the pool.)
c. Click the Options button. The Pool Options screen is displayed.
4. In the Pool Options screen, click the Insert button.