WESM zl Management and Configuration Guide WT.01.28 and greater

1-35
Introduction
ProCurve Wireless Edge Services zl Module
Controlling Traffic Manually. You can also control traffic according to manually
created rules on the Wireless Edge Services zl Module; however, such policies are
generally less flexible.
You can control these settings:
■ VLAN assignment—When configuring VLAN assignments manually, you
must assign an entire WLAN to the same VLAN. For example, suppose users
A, B, and C connect to WLAN 1. User A is in the Marketing department, user
B is in the Engineering department, and user C is a guest. With either an external
or the module’s internal RADIUS server, you can configure the module to place
each user in a different VLAN. If you manually configure the settings on the
Wireless Edge Services zl Module, you must place all the users in the same
VLAN, as shown in Figure 1-13.
Figure 1-13. Assigning VLANs Manually
For instructions on configuring the VLAN assignment, see Chapter4: “Wireless
Local Area Networks (WLANs).”
■ Filters (or ACLs)—The Wireless Edge Services zl Module’s internal firewall
supports a variety of options for ACLs, which are described in “ACLs” on
page 1-38. Depending on the ACL type, you can control traffic based on source
address, destination address, application, WLAN, 802.1p priority, and other
criteria.
You cannot configure rate limits manually.