WESM zl Management and Configuration Guide WT.01.28 and greater

6-46
IP Services—IP Settings, DHCP, and DNS
DHCP Server
Figure 6-31. Add Relay Information Screen
3. In the Interface field, use the drop-down menu to select the VLAN interface that
receives the DHCP requests.
4. In the Server fields, enter the IP addresses for up to four DHCP servers. In each
applicable Gateway field, use the drop-down menu to specify the corresponding
interfaces by which the DHCP servers may be reached. For example, if the
module’s default gateway knows how to route traffic to the DHCP server, you
would select the default VLAN.
5. Click the OK button.
6. Click the Save link at the top of the Web browser interface to save the changes
to the startup-config.
The configuration is displayed on the Network Setup > DHCP Server > Relay screen.
(See Figure 6-32.) The Interfaces section shows the interface from which DHCP
packets will be forwarded to the DHCP server. The Gateway Information section
shows the server IP address and the interface by which the DHCP server can be
reached.