WESM zl Management and Configuration Guide WT.01.28 and greater

7-13
Access Control Lists (ACLs)
Configuring ACLs
You can configure up to 500 rules for each ACL, no matter what its type.
Creating Rules for Standard IP ACLs
The standard IP ACL offers a variety of options for rules. However, some of these
options only take effect on certain interfaces. As you create the rule, keep in mind
the interface for which you are designing this ACL. In Table 7-3, an X under the
interface means that the option is supported for that interface.
Table 7-3. Valid Options for Standard IP ACLs Depending on Interface
To create a rule for a standard IP ACL, complete these steps:
1. On the Security > ACLs > Configuration screen, in the ACLs section, select a
standard IP ACL.
2. Click the Add button under Associated Rules. The Add Rule screen is displayed.
Option VLAN Interface Uplink Port Downlink Port
deny operation X X X
permit operation X X X
mark operation X X
source IP address
and mask
XXX
WLAN index X