WESM zl Management and Configuration Guide WT.01.28 and greater

8-16
Configuring Network Address Translation (NAT)
Planning the NAT Configuration
Figure 8-7. Dynamic NAT on a Sample Network
For this NAT implementation, you would record the IP addresses specified in the
DHCP pool and configure an ACL that selects those addresses. Table 8-3 lists the
actual IP addresses that you would record for the sample network shown in
Figure 8-7.
Table 8-3. Recording Addresses for Dynamic NAT on a Sample Network
NAT Interface Type
(Inside or Outside)
NAT Address
Type
Local or Global Address Recorded Addresses for the Sample
Network
Inside Source Local (stations’ IP addresses as they
appear on the wireless network)
10.1.1.0/24 subnetwork—assigned through
DHCP and specified in an ACL
Inside Source Global (IP address for all stations as
it appears on the wired network)
192.168.1.10—module’s vlan 1 IP address