WESM zl Management and Configuration Guide WT.01.28 and greater

8-24
Configuring Network Address Translation (NAT)
Configuring NAT
Figure 8-12. Interface Assignment in Security > NAT > Interfaces Screen
Configuring Dynamic NAT
For each NAT configuration that will use dynamic NAT, you must first set up an
ACL. This ACL contains rules that select the source addresses for traffic to be
translated. For information about creating this ACL, see Chapter 7: “Access Control
Lists (ACLs)” and “Configuring Standard ACLs for Dynamic NAT” on page 8-20.
To configure dynamic translation, complete these steps:
1. Select Security > NAT and click the Dynamic Translation tab.