WESM zl Management and Configuration Guide WT.01.28 and greater

10-14
Redundancy Groups
Configuring a Redundancy Group
not hear any heartbeats from the first member, which is waiting for the spanning
tree to be established before transmitting messages. The second member assumes
that the first member is down and may attempt to adopt RPs when it should not.
When you select the Handle STP convergence box, the module waits 50 seconds,
which is the standard time period allowed for STP convergence, before attempt-
ing to establish the redundancy group.
9. Click the Apply button to apply changes to the running-config.
Adding Members to the Redundancy Group
You must manually specify the IP address of every other module in the redundancy
group. Follow these steps to define each member:
1. Select Network Setup > Redundancy Group and select the Member tab.
Figure 10-4. Network Setup > Redundancy Group > Member Screen
2. Click the Add button. The Add Members screen is displayed.