WESM zl Management and Configuration Guide WT.01.28 and greater

10-15
Redundancy Groups
Configuring a Redundancy Group
Figure 10-5. Add Members Screen
3. Enter the IP address of one of the other modules in the redundancy group. This
address should match the address that you configure for the Interface IP in the
other module’s redundancy group settings.
4. Click the OK button. The module is now listed on the Network Setup >
Redundancy Group > Member screen.
5. Repeat this step for each additional module in the redundancy group.
Enabling Redundancy
After you enable redundancy, the Wireless Edge Services zl Module begins commu-
nicating with other modules and establishing the redundancy group. Completely
configure the redundancy group before enabling redundancy. After you enable
redundancy, you can no longer alter settings or add new members.
Follow these steps:
1. Click the Configuration tab to return to the Network Setup > Redundancy Group
> Configuration screen.
2. Check the Enable Redundancy box. The redundancy group configuration options
are now dimmed. You also cannot change the member configuration (on the
Member tab) while redundancy is enabled.