WESM zl Management and Configuration Guide WT.01.28 and greater

10-17
Redundancy Groups
Configuring a Redundancy Group
Viewing Information about the Redundancy Group
To view information about the redundancy group, select Network Setup > Redun-
dancy Group and select the State tab.
Figure 10-7. Network Setup > Redundancy Group > State Screen
After the primary module and the redundant modules establish a redundancy group,
each module tracks the following information about the group:
■ Redundancy state is—This field lists the current state of the module. Both
primary and redundant modules go through the same redundancy states:
• Disabled
•Startup
•Discovery
• Online
If this module is running redundancy, its state is Online.