WESM zl Management and Configuration Guide WT.01.28 and greater

11-32
RADIUS Server
RADIUS Authentication
If the client has more than one IP address, make sure to specify the address that
it includes in RADIUS requests.
5. In the Shared Secret field, enter the client’s password.
Of course, you must specify this same password when you configure the client
device to query this module.
6. Click the OK button. The client is displayed in the Network Setup > Radius
Server > Configuration screen under the Clients tab.
7. Click the Save link at the top of the Web browser interface to save the changes
to the startup-config.
Starting and Stopping the RADIUS Server
You must restart the RADIUS server for configuration changes to take effect. The
Web browser interface automatically asks you to restart the server whenever you
make a configuration. You can also manually stop and start the server from the
Network Setup > Radius Server > Configuration screen.
The Global Settings section indicates whether the server is running:
■ “Start the RADIUS server”—The server is currently disabled.
■ “Stop the RADIUS server”—The server is currently enabled.
To change the RADIUS server’s status, click link portion of the indication. To disable
the server, click the Stop link. To re-enable a stopped server, click the Start link.
In either case, a screen is displayed, informing you of the change in status.
Figure 11-15.Restarting the RADIUS Server
Click the OK button to close the screen, remembering to save your configuration by
clicking the Save link.