WESM zl Management and Configuration Guide WT.01.28 and greater

12-37
Wireless Network Management
Monitoring the Wireless Network
Figure 12-24.Device Information > Radio Adoption Statistics > Adopted RP Screen
Select the Adopted RP tab to view the RPs that the module has actually adopted, and
the Unadopted RP tab to view other detected RPs.
The number of RPs adopted by this module is listed at the bottom of the Device
Information > Radio Adoption Statistics > Adopted RP screen.
For each adopted RP, the screen lists:
■ Base Radio MAC—This is the MAC address on the RP’s Ethernet interface.
■ Model—The Wireless Edge Services zl Module adopts only ProCurve Radio
Ports 210, 220, or 230.
■ Serial—The serial number is unique to this device.
■ HW Version—This column indicates the hardware used by the RP.
■ IP Address—This column displays an IP address if you have configured Layer 3
adoption for RPs. For more information about Layer 3 adoption, see Chapter 2:
“Configuring the ProCurve Wireless Edge Services zl Module.”
■ Bootloader—This column indicates the software from which the RP boots.
■ Protocol Version—RPs and the Wireless Edge Services zl Module communicate
with a particular protocol. If an RP experiences problems, you should verify that
the two devices’ protocol versions match. Also check the hardware version and
the bootloader version.
■ SW Version—You should verify that the software version with which the RP
loads is up-to-date.