WESM zl Management and Configuration Guide WT.01.28 and greater

12-64
Wireless Network Management
Logging and Alarms
Configuring Logging
To configure logging, select Management > System Logging > Log Options.
Enabling Logging
As shown in Figure 12-45, logging is enabled by default, and the Wireless Edge
Services zl Module logs events to:
■ Its buffer—The module saves events that have collected in the buffer to its local
log as they occur. Viewing this log is described in “Viewing Events in the Local
Log File” on page 12-66. You can disable this feature by unchecking the Enable
logging to Buffer box.
By default, the module logs all events of severity level 3 or lower (more
severe)—that is, all events from severity level 0 through level 3. You can raise
or lower this level according to the needs of your network by selecting a level
in the Enable logging to Buffer drop-down menu. Keep in mind that the higher
the level, the more events through which you will have to search.
■ The console—If you are managing your module through the console port, events
will appear on the command line as they occur. You can disable this feature by
unchecking the Enable logging to Console box. By default, events of severity
level 3 or lower (more severe) are listed; you can raise or lower this setting.