WESM zl Management and Configuration Guide WT.01.28 and greater

12-78
Wireless Network Management
MAC Filters (Local MAC Authentication)
3. Enter a value from 1 through 1,000 in the Station-ACL Index field. Each ACL
must have a unique index number. Pay close attention to this number because,
when a station matches more than one entry, only the entry with the lowest
number affects the station.
4. Enter a range of MAC addresses, placing the first address in the Starting MAC
field and the last address in the Ending MAC field. Every MAC address between
the two is included in the list. You cannot add noncontiguous MAC addresses to
the ACL; instead, you must create a new ACL.
5. Using the Allow/Deny drop-down menu, select whether the module will permit
traffic from these stations (Allow) or block it (Deny).
6. Click the OK button.
The ACL is listed on the Security > MAC Filters screen.
Configuring WLAN Memberships
The ACL will not affect traffic until you associate the ACL with one or more WLANs.
To do so, you make the ACL a member of those WLANs.
Complete these steps:
1. On the Security > MAC Filters screen, select the ACL.
You can select multiple ACLs by holding down
Ctrl as you select them.
2. Click the Memberships button. The Edit Memberships screen is displayed. (See
Figure 12-55.)