WESM zl Management and Configuration Guide WT.01.28 and greater

12-93
Wireless Network Management
Network Self Healing
2. Select a radio and click the Edit button. The Edit Neighbor screen is displayed.
(See Figure 12-66.)
Figure 12-66.Editing Neighbors
The available RP radios—those adopted by this module—are listed on the left
under Available Radios: these are potential neighbors.
3. To add a neighbor, select a radio from the field on the left and then click the Add
button. The radio moves to the right; it is now the neighbor of the radio that you
are editing.
You can add up to 16 neighbors, including radios that use a different 802.11 mode
than the radio for which you are selecting neighbors. Keep in mind, however,
that if the second radio’s wireless stations do not support the other mode, then
this radio cannot help them.
4. To remove a radio from the neighbor list, select that radio from the list on the
right and click the Remove button.
5. In the Self Healing Action field, use the drop-down menu to select the action that
this radio takes when a neighbor fails. Because you must also complete this step
when you use automatic neighbor detection, configuring this setting is described
in “Selecting the Self-Healing Action” on page 12-94.
6. Click the OK button.