WESM zl Management and Configuration Guide WT.01.28 and greater

13-6
sFlow Agent
Configuring sFlow Using the Web Browser Interface
Configuring sFlow Using the Web Browser
Interface
The Wireless Edge Services zl Module’s sFlow agent is enabled by default. If your
sFlow receiver (sometimes called an sFlow collector) can control the agent through
SNMP, you do not need to configure the module further.
You can check the module’s sFlow agent and verify that it is compatible with your
sFlow receiver’s SNMP capabilities. Select Special Features > sFlow > Agent.
Figure 13-1. Special Features > sFlow > Agent Screen
In order to manage an sFlow agent, an sFlow receiver must know how the agent
implements sFlow. The screen displays this information about the agent:
■ sFlow MIB Version—the agent’s MIB version. The MIB specifies how the agent
extracts and bundles sampled data, and the sFlow receiver must support the
agent’s MIB. The Wireless Edge Services zl Module’s MIB version is 1.3, so
your sFlow collector’s version must also be at least 1.3.