WESM zl Management and Configuration Guide WT.01.28 and greater

A-107
ProCurve Wireless Services zl Module Command Line Reference
Wireless Commands
mtu
This command sets the mtu value for the vlan interface.
Syntax
mtu (<512-1500>)
• <512-1500> - MTU in bytes.
Default Setting
N/A
Command Mode
Interface Configuration
Example
Wireless Commands
These commands are used to configure the Wireless Context commands.
HPswitch#configure
HPswitch(config)#interface vlan1
HPswitch(config-if)#mtu 600
HPswitch(config-if)#
Command Function Page
[no] adopt-unconf-radio (Negates) Adopts an unconfigured radio. A-
108
[no] adoption-pref-id (Negates) Configures a preference identifier. A-
109
[no] advanced-config (Negates) Enables advanced configuration. A-
109
[no] ap-detection (Negates) Configures neighboring access point
detection.
A-
110
[no] dot11-shared-key-auth (Negates) Enables support for 802.11 shared key
authentication.
A-111
end Detailed in Global Command Section. A-63
exit Detailed in Manager Command Section. A-8