WESM zl Management and Configuration Guide WT.01.28 and greater

A-112
ProCurve Wireless Services zl Module Command Line Reference
Wireless Commands
Example
ids
This command configures the Intrusion Detection configuration commands. The no
command negates the configuration.
Syntax
ids (anomaly-detection | detect-window| ex-ops)
no ids
Default Setting
N/A
Command Mode
Wireless Configuration
Example: Intrusion Detection System (IDS) commands can be used to filter a station
that set off IDS. Setting the following ids parameters will blacklist the client for the
amount of time set in the ageout (ageout time can be up to one day).
60 in this example is the ageout duration (seconds) in which mobile units will be
filtered out. A value of 0 - 86400 seconds can be configured.
Related Commands
show wireless ids (page A-166)
HPswitch(wireless-services-E(config-wireless)#dot11-shared-
key-auth enable
HPswitch(wireless-services-E(config-wireless)#
HPswitch#configure
HPswitch(config)#wireless e
HPswitch(wireless-services-E)#config
HPswitch(wireless-services-E)(config)#wireless
HPswitch(wireless-services-E)(config-wireless)#ids anomaly-
detection tkip-countermeasures enable
HPswitch(wireless-services-E)(config-wireless)#ids anomaly-
detection tkip-countermeasures filter-ageout 60