WESM zl Management and Configuration Guide WT.01.XX and greater

2-79
Configuring the ProCurve Wireless Edge Services zl Module
Radio Port Adoption
The default username and password on all ProCurve 200 Series RPs are admin
and procurve.
ProCurve Networking suggests that you use pre-adoption to change these
settings, using a Wireless Edge Services zl Module to load new credentials on
your organization’s RPs. You can then move these RPs to their final locations
and be sure that only these RPs can connect to your network.
Configuring 802.1X Authentication for RPs
To configure 802.1X authentication for RPs, complete these steps:
1. Select Network Setup > Radio > Configuration.
2. Click the Global Settings button. The Global screen is displayed.
Figure 2-45. Radio Global Settings Screen
3. Click the Configure Port Authentication button. The Configure Port Authenti-
cation screen is displayed.