WESM zl Management and Configuration Guide WT.01.XX and greater

7-10
Access Control Lists (ACLs)
Configuring ACLs
Configuring ACLs
To configure an ACL, you must complete these steps:
1. Create the list and select the ACL type.
2. Create a series of ordered permit, deny, or mark rules.
3. Apply the list to an interface.
Do not complete the final step if you are using a standard IP ACL for a function
other than controlling traffic. These functions include:
■ NAT—The ACL selects traffic for dynamic source NAT; you specify the
ACL in the NAT configuration. See Chapter 8: “Configuring Network
Address Translation (NAT).”
■ secure Network Time Protocol (NTP)—The ACL selects which hosts
are allowed to send specific types of NTP communications. See “Applying
ACLs to NTP Services” on page 2-146 of Chapter 2: “Configuring the
ProCurve Wireless Edge Services zl Module.”
Creating ACLs
To create an ACL, complete these steps:
1. Select Security > ACLs > Configuration.