WESM zl Management and Configuration Guide WT.01.XX and greater

1-37
Introduction
ProCurve Wireless Edge Services zl Module
If you are using your Wireless Edge Services zl Module’s internal RADIUS
server, you can set this user-based policy: VLAN ID.
Controlling Traffic Manually. You can also control traffic according to
manually created rules on the Wireless Edge Services zl Module; however,
such policies are generally less flexible.
You can control these settings:
■ VLAN assignment—When configuring VLAN assignments manually, you
must assign an entire WLAN to the same VLAN. For example, suppose
users A, B, and C connect to WLAN 1. User A is in the Marketing depart-
ment, user B is in the Engineering department, and user C is a guest. With
either an external or the module’s internal RADIUS server, you can
configure the module to place each user in a different VLAN. If you
manually configure the settings on the Wireless Edge Services zl Module,
you must place all the users in the same VLAN, as shown in Figure 1-13.
Figure 1-13. Assigning VLANs Manually
For instructions on configuring the VLAN assignment, see Chapter 4:
“Wireless Local Area Networks (WLANs).”
■ Filters (or ACLs)—The Wireless Edge Services zl Module’s internal
firewall supports a variety of options for ACLs, which are described in
“ACLs” on page 1-40. Depending on the ACL type, you can control traffic
based on source address, destination address, application, WLAN, 802.1p
priority, and other criteria.
You cannot configure rate limits manually.