WESM zl Management and Configuration Guide WT.01.XX and greater

13-10
sFlow Agent
Configuring sFlow Using the Web Browser Interface
Figure 13-3. Receiver Configuration Screen
4. In the Owner field, enter a string to identify the sFlow receiver.
5. In the Time Out field, specify a value in seconds from 1 to 999999999
(roughly 31 years).
The timeout reserves this receiver instance for the specified receiver for
the set amount of time. Generally, when you configure an sFlow receiver
instance manually, you should set the timeout very high (to days or
weeks). All settings in the instance are erased when the timeout expires,
and you do not want to reconfigure the instance frequently.
Always set a timeout. If you attempt set the timeout field to 0, your settings
are immediately lost.
6. In the Maximum Datagram Size field, enter the maximum size of an sFlow
datagram in bytes.
The valid range is from 800 to 1400 bytes, and the default is 1400. The
primary reason to lower the size would be that devices between the
Wireless Edge Services zl Module have low MTUs, but you do not want
them to fragment the datagram.
7. In the Receiver Address field, enter the sFlow receiver’s IP address.
8. In the Receiver Port field, accept the default port (6343) or enter the UDP
port used by this receiver.
The valid range is from 1 to 65535.