WESM zl Management and Configuration Guide WT.01.XX and greater

A-83
ProCurve Wireless Services zl Module Command Line Reference
GlobalCommands
• groupid Set the redundancy group id
– <165535> Redundancy group Id
• handlestp Delay the redundancy protocol state machine exec, con-
sidering STP
– enable Set handlestp to true
• heartbeatperiod Set the redundancy heartbeat interval.
– <1255> heartbeat interval in secs (default is 5)
• holdperiod Set the redundancy hold interval.
– <10255> hold interval in secs (default is 15)
• interfaceip Set redundancy interface IP address
– A.B.C.D IP address of the wireless module
• manualrevert Revert standby to nonactive mode
• memberip Add member to this redundancy group
– A.B.C.D IP address of the member
• mode set the redundancy mode
– active mode can be active
– standby mode can be standby
Default Setting
N/A
Command Mode
Global
Example
Related Commands
show redundancy (page A-148)
HPswitch#configure
HPswitch(config)#redundancy interfaceip 10.10.1.20
HPswitch(config)#redundancy memberip 10.10.1.21
HPswitch(config)#redundancy mode active
HPswitch(config)#redundancy holdperiod 20
HPswitch(config)#redundancy groupid 50
HPswitch(config)#redundancy handlestp enable
HPswitch(config)#redundancy discoveryperiod 10
HPswitch(config)#redundancy holdperiod 10
HPswitch(config)#