WESM zl Management and Configuration Guide WT.01.XX and greater

A-112
ProCurve Wireless Services zl Module Command Line Reference
Wireless Commands
dot11-shared-key-auth
This command enables support for 802.11 shared key authentication. The no
command negates the support.
NOTE Shared key authentication has known weaknesses that can compromise your
WEP key. It should only be configured to accommodate wireless stations that
are unable to carry out Open-System authentication.
Syntax
dot11-shared-key-auth (enable)
no dot11-shared-key-auth
• enable- Enables support for shared key authentication.
Default Setting
N/A
Command Mode
Wireless Configuration
Example
ids
This command configures the Intrusion Detection configuration commands.
The no command negates the configuration.
Syntax
ids (excessive-associations | excessive-probes | filter-ageout)
no ids
• excessive-associations - Monitors the number of association requests
from stations.
– <0-65535> - Maximum number of association requests per second .
• excessive-probes - Monitors the number of probe requests from
stations.
– <0-65535> - Maximum number of association requests per second .
HPswitch#configure
HPswitch(config)#wireless
HPswitch(config-wireless)#dot11-shared-key-auth enable
HPswitch(config-wireless)#