WESM zl Management and Configuration Guide WT.01.XX and greater

A-115
ProCurve Wireless Services zl Module Command Line Reference
Wireless Commands
radio
This command configures the radio parameters. The no command negates the
radio parameter configuration.
Note To configure many of the radio parameters, you must first configure the
country code. See country code.
Syntax
radio ( <1-1000> | RADIO | add | all-11a | all-11bg | configure-8021X | default-11a | default-
11bg )
no radio
• <1-1000> - A single radio index.
• RADIO - A list (eg: 1,3,7) or range (eg: 3-7) of radio indices.
• all-11a - All 11a radios currently in configuration.
• all-11bg - All 11bg radios currently in configuration.
• default-11a - Default 11a configuration template.
• default-11bg - Default 11bg configuration template.
The radio (<1-1000> | RADIO | all-11a | all-llbg | default-11a | default-11bg)
commands share the following parameters:
– adoption-pref-id - A preference identifier for this radio port. The
radi o p or t i s mor e li ke ly to be ado pt e d b y a wir el e s s modul e
that is its preferred wireless module.
+<1-65535> - The ID.
– antenna-mode - Antenna diversity mode.
+diversity - Full Diversity (both antennas).
+primary - Primary Antenna only.
+secondary - Secondary Antenna only.
– beacon-interval - Beacon interval in K-uSec.
+<50-200> - Beacon interval in milliSeconds.
– bss - Map wireless LANs to radio BSSIDs.
+<1-4> - The BSS where wireless LANs will be mapped.
- WLAN - A list (eg: 1,3,7) or range (eg: 3-7) of WLAN indices.
When a BSS is also specified, the first WLAN will be used as
the primary WLAN. When the auto option is used, the system
will automatically assign the first four WLANs as primaries
on their respective BSS.
+auto - Automatic assignment of BSS. The user selects wireless
LANs, and the system assigns them to a BSS automatically.