WESM zl Management and Configuration Guide WT.01.XX and greater

A-120
ProCurve Wireless Services zl Module Command Line Reference
Wireless Commands
Example
Related Commands
show wireless self-heal-config (page A-178)
wlan
This command configures the wireless LAN parameters. The no command
negates the WLAN parameter configuration.
Syntax
wlan ( <1-32> | WLAN )
no wlan
• <1-1000> - A single WLAN index.
• WLAN - A list (eg: 1,3,7) or range (eg: 3-7) of WLAN indices.
The radio (<1-1000> | WLAN ) commands share the following parame-
ters:
– authentication-type - The authentication type of this WLAN.
+eap - EAP authentication (802.1X).
+none - None / pre-shared keys.
+web-auth - Web based authentication (Note: encryption-type will
be changed to none).
– closed-system - Hides the SSID in beacons, and doesn’t respond
to probes for broadcast ESS on this WLAN.
– description - The description of this WLAN.
+LINE - A string of up to 20 characters.
– dot11i - Configures IEEE 802.11i (TKIP/AES) parameters.
+key - Configures the key (PMK).
-0 - Password is specified UNENCRYPTED.
++WORD - The 256 bit (64 hex characters) long key.
HPswitch#configure
HPswitch(config)#wireless
HPswitch(config-wireless)#self-heal interference-avoidance
enable
HPswitch(config-wireless)#self-heal neighbor-recovery enable
HPswitch(config-wireless)#self-heal neighbor-recovery
neighbors 5 5
HPswitch(config-wireless)#self-heal neighbor-recovery run-
neighbor-detect
HPswitch(config-wireless)#