Wireless Edge Services xl Module Release Notes WS.02.12

Software Fixes

Release WS.02.12

■ Wireless (41324) — Access point detection requires that either the Single channel scan for

Unapproved APs or Dedicate this Radio as a Detector is enabled in the radio configuration, but

Single channel scan for Unapproved APs has no affect if the Self Healing feature is enabled. With

this fix, rogue radios no longer show up when a radio port is part of a self-healing group

unless single channel scan is enabled.

■ Wireless (41389) — The ProCurve IDM QoS setting is not being applied in the proper

direction.

■ Wireless (41482) — When devices using power save mode re-associate with a radio port,

they may have connectivity issues. When this happens to SVP phones, the phones will display

a message similar to Unable to contact PRI gateway when they try to re-associate.

■ Wireless (41320) — The TIM bit (in the wireless beacon) is not getting cleared when SVP

phones in power save mode re-associate.

■ Wireless (41711) — Wireless stations should be allowed to transmit and receive data

directly following a 4-way WPA handshake, rather than waiting for the 2 message group key

handshake messages afterward. This causes communication failure in certain clients.

■ Wireless (41341) — Rogue AP detection continues to detect unapproved AP's even when

AP detection and (self-healing) scanning are both disabled.

Release WS.02.12

Problems Resolved in Release WS.02.12

■ Applet (42774) — The Web Management Interface does not allow variable length subnet

masks in the screens that add a DHCP Network Pool for a VLAN interface.

■ IDM (746917) — The IDM process was not available.

■ SFlow (746921) — The sFlow process was not available.