Wireless/Redundant Edge Services xl Module Management and Configuration Guide WS.01.03 or greater

2-36
Configuring the ProCurve Wireless Services xl Module
Radio Port Adoption
Configuring Manual Adoption for RPs
To manually adopt RPs, you must edit the global settings for RPs:
1. Click Network Setup > Radio and select the Configuration tab.
2. Click the Global Settings button.
Figure 2-20. Network Setup > Radio > Global Settings Screen
3. Click the Adopt unconfigured radios automatically box to remove the check
mark.
4. Click OK to apply the change to the running-config.
5. Determine the MAC address of the RPs that you want to manually adopt.
a. Click Device Information > Radio Port/LAN Statistics and select the
Unadopted tab. The unadopted RPs and their MAC addresses are listed
on this screen.
b. Record the MAC address of the RP that you want to adopt so that you
can enter it later.