Wireless/Redundant Edge Services xl Module Management and Configuration Guide WS.01.03 or greater

2-43
Configuring the ProCurve Wireless Services xl Module
System Maintenance
■ Next Boot—This field determines if the software image will be used to
boot the Wireless Edge Services xl Module the next time the module is
reloaded. A green check mark indicates the image will be used; a red x
indicates the image will not be used.
■ Built Time—This field reports the date and time that this software image
was created.
■ Install Time—This field reports the date and time that this software
image was updated on the Wireless Edge Services xl Module.
Selecting the Software Image That Is Used to Reboot
You can specify which software image the Wireless Edge Services xl Module
will use the next time it is rebooted—the primary or the secondary. Complete
the following steps:
1. Click Management > System Maint.—Software.
2. Select the software image that the Wireless Edge Services xl Module
should use to boot. For example, if you want the module to boot with the
secondary image, select that image.
3. Click the Edit button at the bottom of the screen.
Figure 2-26. Update Software Image Dialog Box
4. Check the Use this software on next reboot box.
5. Click OK.
6. To save this change to the startup-config, click the Save button at the
bottom of the navigation bar.