Wireless/Redundant Edge Services xl Module Management and Configuration Guide WS.01.03 or greater

2-47
Configuring the ProCurve Wireless Services xl Module
System Maintenance
Configuration Files
The Wireless Edge Services xl Modules ships with a factory default startup-
config file. Factory default settings include:
■ support for HTTP and HTTPS
■ support for SNMP v1, v2, and v3
■ DHCP-assigned IP address for the default management interface
As you configure the Wireless Edge Services xl Module and save changes,
these changes are saved to the startup-config. From the Web browser inter-
face, you can view the commands included in the startup-config file, or you
can return the startup-config file to factory default settings.
For backup purposes, you can save the startup-config file to:
■ FTP server
■ TFTP server
■ workstation’s hard drive
In addition, you can save multiple configuration files and store them in the
module’s internal flash. As Table 2-1 shows, configuration files are stored in
two locations in the module’s internal flash.
Table 2-1. Configuration Files Stored in Internal Flash
Viewing Configuration Files
To view a configuration file, access the Management > System Maint.—Config
Files screen. As shown in Figure 2-30, this screen displays the following
information about each configuration file saved in flash:
■ Name
■ Size (Bytes)
■ Created—date and time the file was created
■ Modified—date and time the last time the file was changed
Name of Configuration File Location in Internal Flash
startup-config NVRAM
other configuration files flash