Wireless/Redundant Edge Services xl Module Management and Configuration Guide WS.01.03 or greater

2-53
Configuring the ProCurve Wireless Services xl Module
System Maintenance
3. Specify the destination.
a. Specify an FTP or TFTP server as the destination.
i. In the To field under Target, use the drop-down menu to select
Server.
ii. In the File field, enter the name of the configuration file.
iii. In the Using field, use the drop-down menu to select either FTP or
TFTP.
iv. In the IP Address field, enter the IP address of the FTP or TFTP
server.
v. If you are using an FTP server, enter a username in the User ID
field and enter the password in the Password field.
vi. In the Path field, enter the path where the configuration is saved
on the server. (Depending on your server, this field may not be
required.)
b. Specify the Wireless Edge Services xl Module as the destination.
i. In the To field under Target, use the drop-down menu to select
Wireless Services Module.
i. Enter the name that you want to give the configuration file.
c. Specify the local hard drive as the destination.
i. In the To field under Target, use the drop-down menu to select
Local Disk.
i. Enter the name that you want to give the configuration file.
ii. Use the Browse button to select the directory in which you want
to store this configuration file.
4. Click the Transfer button. In the Status area at the bottom of the screen, a
message is displayed, reporting if the transfer was successful.
Deleting a Configuration File
From the Management > System Maint.—Config Files screen, you can delete
any configuration file that is stored in flash—except the startup-config file. To
delete a configuration file, complete the following steps:
1. Select the configuration file and click the Delete button. As shown in
Figure 2-34, you will be prompted to confirm that you want to delete this
configuration file.