Wireless/Redundant Edge Services xl Module Management and Configuration Guide WS.01.03 or greater

2-54
Configuring the ProCurve Wireless Services xl Module
System Maintenance
Figure 2-34. Confirm File Delete Prompt
2. Click Yes to delete the file.
Note If you attempt to delete the startup-config file, the Web browser interface
allows you to go through the steps of deleting the file, but when you confirm
that you want to delete the file, the following message is displayed at the
bottom of the navigation bar:
You have selected the system startup-config file. This file cannot be edited.
Rather than trying to delete the startup-config file when you are using the Web
browser interface, you should return the file to factory default settings, as
explained in the next section. (You can enter the erase command in the CLI to
delete the startup-config. The module then uses the factory default startup-
config file.)
Returning the Startup-Config File to Factory Default Settings
Although you cannot delete the startup-config file if you are using the Web
browser interface, you can return this file to factory defaults.
1. In the Management > System Maint.—Config Files screen, select the
startup-config file and click Restore Defaults. A prompt is displayed, asking
you to verify that you want to return the startup-config file to factory
defaults.
Figure 2-35. Restore Factory Defaults Prompt