Wireless/Redundant Edge Services xl Module Management and Configuration Guide WS.01.03 or greater

3-10
Wireless Local Area Networks (WLANs)
Configuration Options: Normal Versus Advanced Mode
While you can configure WLANs 1 through 4 to operate in closed system, doing
so does not enable any WLANs that may share their BSSIDs to operate in open
system. The RP simply does not send the SSID for any WLAN on beacons from
that BSSID. See “Enabling Closed System Operations” on page 3-54 to learn
how to configure this feature.
Again, note that the WLAN assignments are constant. If, for whatever reason,
you configure and enable WLANs 2, 4, 5, and 6 instead of 1, 2, 3, and 4, SSID B
(WLAN 2) is assigned to BSSID 2, not BSSID 1. SSID F (WLAN 6) is also
assigned to BSSID 2, and no SSID is assigned to BSSID 3. (See Figure 3-6.)
Figure 3-6. Enabling Out of Sequence WLANs
Table 3-1 shows the BSSID to which all 16 WLANs available in normal mode
are always assigned.