Wireless/Redundant Edge Services xl Module Management and Configuration Guide WS.01.03 or greater

3-60
Wireless Local Area Networks (WLANs)
Configuring a WLAN
Figure 3-36. Enabling a WLAN
4. The icon in the Enabled column should change from a red X to a green
check mark, as shown in Figure 3-36.
As long as you are operating in normal mode, all radios on all RPs that the
module has adopted or will adopt support the enabled WLANs.
You can confirm that RPs are actually supporting the enabled WLANs by
selecting Network Setup > Radio > WLAN Assignment. Select an RP radio to
view which SSIDs are mapped to that radio’s BSSIDs.
The radio also adds the enabled WLANs to the WLAN assignment for default
radio adoption configurations, which you can view by selecting Network
Setup > Radio Adoption Defaults > WLAN Assignment.
Figure 3-37, for example, shows the default configuration after you enabled
the four WLANs shown in Figure 3-36.