Wireless/Redundant Edge Services xl Module Management and Configuration Guide WS.01.03 or greater

3-76
Wireless Local Area Networks (WLANs)
Traffic Management (QoS)
Enabling WMM on a WLAN
When you enable WMM on a WLAN, you are enabling it on the upstream
traffic. That is, RPs send WMM queue settings to wireless stations, which
WMM-enabled stations use to prioritize traffic. These settings will be referred
to as the station WMM parameters, and they differ from those RPs use for
downstream traffic. (For more information about the parameters for down-
stream traffic, see Chapter 5: Radio Port Configuration.)
To enable WMM prioritization on a WLAN’s upstream traffic:
1. Select Network Setup > WLAN Setup > Configuration.
2. Select the WLAN from the list.
3. Click Edit.
4. In the Advanced section of the screen that displays, check the Enable WMM
box, as shown in Figure 3-45.
5. Click OK.