Wireless/Redundant Edge Services xl Module Management and Configuration Guide WS.01.03 or greater

4-20
Redundancy Groups
Configuring a Redundancy Group
Viewing Information about the Other Member in the
Redundancy Group
In addition to viewing information about the redundancy group, you can view
information about the other member of the group. Click Network Setup >
Redundancy Group and select the Member tab. (See Figure 4-11.)
Figure 4-11. Network Setup > Redundancy Group > Member Screen
You can review the following information about the member:
■ IP Address
■ State—what the module knows about this member
• Configured—The member is configured on the current module but no
additional information is known about the member.
• Seen—The module has exchanged heartbeats with this member.
• Invalid critical redundancy configuration parameter(s)—The redun-
dancy group settings on the member (including heartbeat time, dis-
covery time, hold time, redundancy ID, and redundancy protocol
version) do not match the configuration on this module.