Wireless/Redundant Edge Services xl Module Management and Configuration Guide WS.01.03 or greater

5-26
Radio Port Configuration
Configuring Radio Settings
Figure 5-10. Network Setup > Radio > Configuration Screen
The Network Setup > Radio > Configuration screen lists all the radios that the
Wireless Edge Services xl Module has identified and their current settings and
status. Radios are listed by index number. (The first radio that the module
identifies is typically assigned the first index and so forth.) Radios are further
identified by a description and type.
Refer to the Adopted column to determine whether an identified radio has
actually been adopted.
Note An RP does not have to be adopted before you create a configuration for its
radio or radios. It can simply be identified in the list. Select the unadopted
radio, click Edit, and create the configuration. The module deploys the config-
uration after you allow it to adopt the RP.
The list displays two MAC addresses for each radio. The first, in the RP Ethernet
MAC column, is the address on the RP’s Ethernet interface. The second, in the
Base Radio MAC column, is the address on that radio. As you can see in Figure
5-10, two radios can be on the same RP and have the same RP Ethernet MAC
address.
The radio’s State indicates whether it operates as a master for associated
stations (Normal) or exclusively scans for neighboring APs (Detector).