Wireless/Redundant Edge Services xl Module Management and Configuration Guide WS.01.03 or greater

5-34
Radio Port Configuration
Configuring Radio Settings
5. Depending on its channel, placement, and other factors discussed in
“Setting the Desired Radio Power” on page 5-14, a particular radio might
need to use a different power from that in the radio adoption default
configuration. Determine this power, being careful to comply with your
country's regulations, and select it from the Desired Power (dBm) drop-
down menu.
6. After you configure the radio's power level, channel, and placement, the
radio’s RF output is displayed in the Actual column in mW.
7. Click OK.
Run ACS. If you have configured one or more radios to use ACS, you can
have the Wireless Edge Services xl Module reinitiate the ACS process.
Click the Run ACS Now button in the Network Setup > Radio screen.
The Wireless Edge Services xl Module scans all channels and discovers which
radios are adopted and using which channels. The module then analyzes the
radios' channels and moves each ACS-enabled radio to the channel where it
is least likely to experience interference from other radios. (See Figure 5-15.)