Wireless/Redundant Edge Services xl Module Management and Configuration Guide WS.01.03 or greater

6-17
Wireless Network Management
Monitoring the Wireless Network
For each adopted RP, the screen lists:
■ Base Radio MAC—This is the MAC address on the RP’s Ethernet interface.
■ Model—The Wireless Edge Services xl Module only adopts ProCurve
Radio Ports 210, 220, or 230.
■ Serial—The serial number is unique to this device.
■ HW Version—This column indicates the hardware used by the RP.
■ Bootloader—This column indicates the software from which the RP boots.
■ Protocol Version—RPs and the Wireless Edge Services xl Module commu-
nicate with a particular protocol. If an RP experiences problem, you
should verify that the two devices’ protocol versions match. Check the
hardware version and the bootloader version.
■ SW Version—You should verify that the software version with which the
RP loads is up to date.
■ Radio Indices—The RP includes one or two radios. These radios are listed
in the Network Setup > Radio screen according to the indices displayed
in this column. You can configure settings for these radios in that screen.
(See Chapter 5: Radio Port Configuration.)
If you have configured manual radio adoption, the module may detect RPs
that it is not authorized to adopt. These RPs are listed in the Device Informa-
tion > Radio Port/LAN Statistics > Unadopted RP screen. (See Figure 6-10.)
You should review this screen to determine whether you need to manually add
an unadopted RP (see Chapter 2) or find and remove an unauthorized RP. The
screen lists this information:
■ Index—RPs are listed in the order in which they are detected.
■ MAC Address—This is the MAC address on the RP’s Ethernet interface.
■ Last Seen (In Seconds)—View this setting to determine how recent the
information about this RP is.