Wireless/Redundant Edge Services xl Module Management and Configuration Guide WS.01.03 or greater

6-25
Wireless Network Management
AP Detection
Figure 6-16. Viewing the Radio State
6. The radio state should now be listed as Detector in the Network Setup >
Radio screen, as shown in Figure 6-16.
Note The Wireless Edge Services xl Module stores the configuration for a particular
radio with its MAC address so that this configuration persists even if the radio
powers down.
For more information on radio configurations, see Chapter 5: Radio Port
Configuration.
Enable Dedicated Scanning on All Newly-Adopted Radios. To enable
dedicated scanning on all radios of a particular type:
1. Select Network Setup > Radio Adoption Defaults.
2. Highlight the radio type (802.11a or 802.11bg).