Wireless/Redundant Edge Services xl Module Management and Configuration Guide WS.01.03 or greater

6-34
Wireless Network Management
AP Detection
You can view this list in two ways:
■ Select Special Features > Intrusion Detection > Approved APs.
■ Select Device Information > AP Detection > Approved APs.
The approved APs list includes all detected APs that match the criteria for one
of the rules in the Allowed APs screen. For each AP, the list displays informa-
tion similar to that in the unapproved list, as shown in Figure 6-23.
Figure 6-23. Managing the Approved APs List
If a rogue AP is on this list, you should reconfigure the rule that allowed it.
For example, you may need to use MAC addresses rather than, or as well as,
SSIDs to screen APs.
Configuring the Module to Report Unapproved APs
You can configure the Wireless Edge Services xl Module to trigger a Simple
Network Management Protocol (SNMP) trap whenever a radio detects an
unapproved AP: