Wireless/Redundant Edge Services xl Module Management and Configuration Guide WS.01.03 or greater

1-27
Introduction
ProCurve Wireless Edge Services xl Module
You can purchase up to two additive licenses, each of which allows the module
to adopt 12 additional RPs. In other words, a module can be authorized to
adopt up to:
■ 12 RPs (default)
■ 24 RPs
■ 36 RPs
Table 1-5. Maximum RPs Supported with ProCurve Products
You install additive licenses on a particular module, and only that module can
adopt the additional RPs. However, you can move additive licenses.
For example, you install an additive license on a Wireless Edge Services xl
Module so that it can adopt 24 RPs. Later, you decide that a different module
should support the additional RPs. You remove the additive license from the
first module and install it on the second. In other words, instead of moving an
entire module when you want to move RPs within your network, you can move
licenses.
Note You can move only additive licenses. You can never remove a module’s
original license for 12 RPs and install it on another module.
Redundancy Groups
A good network design builds in redundancy so that, in the unlikely event of
a hardware or link failure, users continue to access the resources they need.
In keeping with the ProCurve Networking tradition, the Wireless Edge Ser-
vices xl Module provides cost-effective, scalable, and efficient redundancy.
Products Maximum Number of RPs Maximum Number of
Radios
Wireless Edge Services xl Module
(J9001A)
12 24
Wireless Edge Services xl Module
(J9001A)
Wireless Services Module 12 RPs
License (J9002A)
24 48
Wireless Edge Services xl Module
(J9001A)
2 Wireless Services Module 12
RPs Licenses (J9002A)
36 72