Wireless/Redundant Edge Services xl Module Management and Configuration Guide WS.01.03 or greater

1-45
Introduction
Radio Ports
Note The Radio Port VLAN must be properly established in order for the discovery
messages to reach the module. (See “Communicating with RPs: Radio Port
VLANs” on page 1-4 or the Getting Started Guide for the ProCurve Wireless
Edge Services xl Module.)
After adopting the RP, the module deploys the radio adoption default config-
uration to it, and the RP can begin functioning in your network, as shown in
Figure 1-15.
Figure 1-15. Communications between an RP and the Wireless Edge Services
xl Module