Wireless/Redundant Edge Services xl Module Management and Configuration Guide WS.01.03 or greater

2-5
Configuring the ProCurve Wireless Services xl Module
Management Interfaces
Determine the Dynamic IP Address or Assign a Static Address
Initially, you must access the Wireless Edge Services xl Module through the
CLI—either to determine the IP address that is assigned to the module through
a Dynamic Host Configuration Protocol (DHCP) server or to assign the
module a static IP address.
By default, the module is configured to receive an IP address through a DHCP
server. If you keep this default setting, you can simply access the CLI and
determine the IP address dynamically assigned to the module. You can then
use this IP address to access the Web browser interface and manage the
module.
Alternatively, you can assign the module a static IP address.
To determine the IP address that a DHCP server assigned to the Wireless Edge
Services xl Module, you must access the CLI for the wireless services-enabled
switch. You can use one of the following access methods:
■ Serial session
■ Telnet session
■ SSH session
If you are connecting to the wireless services-enabled switch through a serial
session, use the serial cable (5184-1894) that was shipped with the switch.
Then run terminal session software such as Tera Term or HyperTerminal on
your workstation, setting the following parameters for the session:
■ Baud Rate = 9600
■ Parity = None
■ Data Bits = 8
■ Stop Bits = 1
■ Flow Control = None
When you are prompted for a password, enter the password for the manager
user on the wireless services-enabled switch. Then, access the global config-
uration context by entering:
ProCurve# configure terminal
Move to the wireless-services context by entering:
ProCurve(config)# wireless-services <slot letter>